Год издания: 2018

In most cases, interpretation of resistivity measurements is performed using 1D multilayered formation models that are used to fit data locally in real-time applications. While drilling high-angle or horizontal wells, more complex scenarios may occur, such as faults, pinch-outs, or unconformities. In these cases, resistivity logging data inversion should be performed using at least a 2D model, which is a more complex computational problem. This paper presents a neural networks approach for solving this problem exemplified by the application of a deep azimuthal resistivity tool for geosteering in the vicinity of a tectonic fault. The tool operational frequencies of 400 kHz and 2 MHz produce eight measurements with a coaxial arrangement of transmitters and receivers, and two azimuthally sensitive measurements with axial transmitters and transverse receivers. This paper considers a 2D model of a tectonic fault composed of three parallel layers on the one side of a displacement plane and the same three layers on the other side dislocated at a certain distance along the displacement plane. The model is described with nine independent parameters. The artificial neural networks (ANNs) were designed and trained to calculate the tool signals based on the model parameters. The training was carried out using a synthetic database of 4x105 elements containing the model parameters and corresponding tool signals. The database was calculated using distributed computations with in-house Pie2D software that used the boundary integral equation technique. To estimate the accuracy of the ANNs designed, the signals calculated with the networks were compared against the exact values obtained with Pie2D for an independent sample of 1.8x104 points. The comparison gave a good match for all 10 measurements, with the relative error comprising less than one standard tool measurement error for most points of the sample. Computation with the ANN required a few microseconds to calculate one signal, while the algorithm based on boundary integral equations required several minutes. The obtained acceleration of ∼106 indicates many opportunities for modeling and inversion of logging-while-drilling data.